1.Preparation:Use
an hot iron to press your garment as well as the iron-on
parch, which should be placed under a piece of press
cloth.
|
2.Place the iron-on
patch on where you wish to put on the garment (Note
: rubber print¡¢flock print¡¢heat Transfer¡¢iron-on patch
may be pressed directly onto the garment. Where as parches
with beads, crystal or aluminum should be peeled and
stuck onto the garment.) Then put a piece of clean cloth
on it. |
| 3.When you have
everything ready. Set the temperature of your iron and
ironing time, in accordance with the kind of patch being
used, to the following: For: Rubber print, Med~High,
20 Seconds; Flocking print, High, 20 Seconds; Heat Transfer,
High,50-60 Seconds; Beads, High, 20 Seconds; Aluminum,
High, 15 Seconds. Be sure to use your pressure evenly
when pressing to obtain the best result and wait until
the pattern has completely transferred to the garment,
before putting the iron away. |
4.Remove the clean
cloth and after pattern cools down, peel off the backing
sheet. Now a piece of beautiful garment is ready to
wear. |
